Wrong Engine/Trans - No communication with Motor CAN

[SnowisNej]

Hi,

The board is now in place, there is communication with the Info and Comfort CAN but none with the Motor CAN.

When I go to the MotorInfo it shows the following:
CAN Version: -0-
Transmission: 5HP19
Engine: Petrol Atmo.
Cyl./Valve: 0/-
Idle rev.: 0

My car is a 2004 Audi Allroad with a 2.7t engine and manual 6spd.

Do I need to program it or is there a problem with my installation?

Thanks!

[Remnevolt]

Hi! Perhaps the problem with the installation. Check the connection of the Motor CAN.

[Golf4r36]

Hello, I have something similar with the diagnosis, that it does not connect with the engine control unit with vcds it goes. Motorinfo is correctly displayed. Is there a way for the diagnosis to work?
I habe a r36 dsg in a mk4

[autopilot]

It not connected only to engine ?
Diagnostics for all other ECU is working ?

In VCDS show CAN connection or K-line connection (after enter to motor ECU) ?
Currently CAN-connection in diagnostics enabled only for Audi A48E. For all other cars is disabled in firmware.

[Golf4r36]

Hy in vcds show can. There is no possibility to change it.
Diagnostic for the Other ist Working
Thanks

[autopilot]

By default CAN-diagnostic enabled only for Audi A48E.
How to enable it for other cars see PM.