No Outside-Temp on T4

Disi77 · Post 11 Feb 2022, 11:59

in the Original Dash, i see the Outsidetemp. But not in the Color-MFA... is here a solution? its now Installation-Manual in the Download....

DRIVE2 · Post 11 Feb 2022, 21:43

Please take a picture of all CAN buses in the CAN monitor. All data must be on photo (scroll with up/down button).

Disi77 · Post 17 Feb 2022, 16:44

i cant.... i have no car here for the Signal. I found a solution with resistor, capacitor and coding......

DRIVE2 · Post 17 Feb 2022, 18:38

A resistor, capacitor, and coding solution may solve the problem if the cluster does not support this sensor by default.
But you say that this cluster already displays the temperature ..

Disi77 · Post 21 Feb 2022, 09:23

yes... but i can't check it on Car. He is to far.....

Disi77 · Post 23 Feb 2022, 14:45

can you tell me, wich Signal you want to see? I drive saturday to him ( 220km one way).....

DRIVE2 · Post 23 Feb 2022, 17:22

Did you install in a non-original cluster ? In a "donor" ?
Motor CAN, ID 420, byte2 - must not be 00 or FF. And byte1, bit0 must be 0

Disi77 · Post 25 Feb 2022, 11:14

the Cluster is Original (he say), but what is "donor". When in the Can is 00/ff the solutiuon with resistor, capacitor, and coding? But when ist noz 00/ff what can i do?

DRIVE2 · Post 25 Feb 2022, 12:49

When in the Can is 00/ff the solutiuon with resistor, capacitor, and coding?

Yes.

But when ist noz 00/ff what can i do?

In this situation value must display on screen.