Output Emergency brake, emergency brake 2
Sure. Newer cars automaticaly swith on warning lights (turning lights on both sides), at emergency braking.
ColorMFA put signal on this output if strong deceleration ( more than 0,6 g) is detected. Difference between both modes is continous or blinking output. So you can use a relay to trigger in car built blinking switch, or use relay direct connected to turn lights.
This fuction works excellent...
ColorMFA put signal on this output if strong deceleration ( more than 0,6 g) is detected. Difference between both modes is continous or blinking output. So you can use a relay to trigger in car built blinking switch, or use relay direct connected to turn lights.
This fuction works excellent...
Passat b5, immo 2, 1,8 T APU
Outputs in ColorMFA are ground when active. I made a small circuitry with relay and two inputs - one for emergency braking and second for reverse gear (which signal is + 12V) - both switches warning lights on via built in hazzard switch.
Here is schematics. Transistor must be PNP, BD140 for example. I used universal 1 A diodes - 1N4004 for example.
In Passat b5 relay is paralel connected to hazard switch pins 1,2,3.
Here is schematics. Transistor must be PNP, BD140 for example. I used universal 1 A diodes - 1N4004 for example.
In Passat b5 relay is paralel connected to hazard switch pins 1,2,3.
Passat b5, immo 2, 1,8 T APU