no Oil Temp

[Disi77]

hi build the Color MFA in a 3b0920849 full FIS. but i see no Oil-Temp.... any idea?

[DirtyliMe]

1. check sensor
2. check connection and wire soldering (where did you solder wire from TrInput1?)
3. check dashboard coding

make pics of your soldering (green, blue connectors and mfa board)

[autopilot]

but i see no Oil-Temp

In car is present oil level/temperature sensor ?
On some American cars is not present. Need install manually if it need.

[Disi77]

its a german Car and the Oil-Temp works with the 3dcolor-mfa.

TrInput1 is not connect....

[Disi77]

ok all works. i restart the gateway and now works all fine....

[autopilot]

In what car you installed ColorMFA ?
External gateway ?

[Disi77]

no its a b5.5. After recode/restart the gatway all works. bur i have a nother problem.... i drive 50km and the oil-level warning its on. but you see its enought oil..... every start the cat its "beeep " ans say oil level its to low.....

[autopilot]

What engine on you car ? On this screen MIN is flashed ?
May you make photo of CAN-monitor screen with active only Motor-CAN ? Data on screen is scrollable, need to fit all data to photo. Engine must be worked white make photo.

[Disi77]

ok. i make it. its a passat b5.5 1.9tdi. yes MIN is flashing. its a full fis dash

[autopilot]

Ok. I think I know about this problem.
See PM.

[Awaken]

What did you mean by 'restart the gateway'? I am having also an issue with the oil temp sensor on my s3, trying to avoid opening and resoldering...