S4 B7 installation

[Matze0409]

Hello. I want to install the color mfa on my S4 B7 from 2005. Now I look for the mfa buttons but my cluster looks different like pictures in the Manual.

[autopilot]

You have original color FIS in cluster ?

[Matze0409]

Yes original color fis

[autopilot]

Base installation points is the same. There are some minor differences.
Not need remove leds behind of original screen. Other placement of components on the cluster PCB.

Main differences present (in photo) here: https://colormfa.ru/download/color2.rar

[Matze0409]

Thank you. That's my cluster on the pictures. No I have the probem. With light fault from Xenon HRC. I have connected triinput 1 to 29 green. And I have no informations on info can

[autopilot]

Your kit is for A48E ? I'm not see you in order list... Do you have photo of your kit ?

Check all connection again...
Always HRC fault = wire not connected or connected to ground (of cource, if real fault is not present).
Info CAN - must work if right connected. Check it. May be you swaped High and Low wires. CAN-High must be connected to CAN-High, CAN-Low to CAN-Low....

[Matze0409]

Pictures of the board

[autopilot]

Kit not for A48E.
Need solder some components.

Need solder this:

[Matze0409]

Can you tell me. The right gear ratio for the S4 Manual transmission?

[autopilot]

Tell me your gearbox code (3 char).

[Patrick-S]

Hello Autopilot. I have the same board installed in my A4 B7. Bought it from a German who had it left. So I am also missing the components on the board. I have no error messages. Only no Infotainment CAN. Is that the reason for it? Can I get the said components and just solder them myself (Of course with some flux etc.) Or is there something that needs to be programmed? Or better order a new board from you? It is then v 3.4 right? If so, when does the new batch start?

[autopilot]

You can solder the components above and for 8E this will be enough.

[Patrick-S]

Thanks Autopilot for the hint with parts to solder. It works well.