ColorMFA

Hi there
I have successfully installed colorMFA into my car:)
I have two question.

1) Boost pressure shows 0.0,
In user manual is written:
Boost pressure (for turbo-engines).
Boost pressure indication requires additional wiring!

So my first question is: Which additional wiring is required to get it works?

2) I installed colorMFA into LowLine cluster.
In installation manual in written:
If the unit was installed into a LowLine cluster, the eeprom dump must be edited to enable the outside air temp
sensor to work. Change address 0x1E5 (501 software) or 0x217 (503 software) from 2B to 2F. Factory MFA and
FIS already have this byte correct

My second question is: What do I have to do ? I am quiet confused. Where do i have to change address?

Thanks for advice

Best regards
Roman

Hi.
It would be nice to specify the car where it is installed ColorMFA.

Which additional wiring is required to get it works?

Подключение наддува
Sorry, but currently only in Russian.

Where do i have to change address?

Outside air temp shown on screen ?
Sensor is installed on car ?

Thanks for reply
Octavia1 1,9TDI-PD 2009 cluster part number: 1U0 920 811 J
Ok I will add this aditional wiring thanks

No outside temp is not shown on screen
I thing sensor is there because I am able to show outside temperature on old display.

Best regards
Roman Fojtik

About outside temp please contact to VampireLo
May be he help you.
Or may use this software: https://www.drive2.ru/l/471768829593126099/
I'm dont know about EEPROM changes on Skoda....