Audi a4 b6 conection problem

Adko13 · Post 31 Oct 2019, 14:28

hello i also have a problem with wiring on b6, After the connection shows only the logo and lights error .. but can not switch and get neither the menu nor anything ...

Instrument cluster Bosch... instrument cluster other than in the instructions
https://www.imageupload.net/upload-imag ... 4384_n.jpg

DRIVE2 · Post 31 Oct 2019, 16:08

In A48E present only Bosch cluster. Your cluster with original color screen or mono screen ?
In instruction present photo of 2 type of mono screen cluster.

Check all connection. I think you wrong connected CAN-bus wires. In A48E all contriol button work only via CAN-bus.

Adko13 · Post 31 Oct 2019, 16:44

I got 4pcs of displays 2x a4 b5 1x a4 b6 1x a3 8l...

Stickers is a4 and a3... 2 is not stickers...
which is for a4 b6?

https://ibb.co/rHMPcJ4
https://ibb.co/xstz0sq

it's possible that I was wrong in the boards

DRIVE2 · Post 31 Oct 2019, 17:09

In your situation possible incorrect kit installed (buttons control from CAN only in A48E firmware).
But I don't know about marking...

I not have selling or shipping info. Need ask Dirtylime about this.

Possible to take photo of screen installed to this cluster ? While it show any info (error, main screen or other), except logo...

Adko13 · Post 31 Oct 2019, 17:16

Shows only logo and lights error ..

DRIVE2 · Post 31 Oct 2019, 17:20

Take photo whith lights error...

Adko13 · Post 31 Oct 2019, 17:56

https://youtu.be/LBztqfehX2Y

DRIVE2 · Post 31 Oct 2019, 18:08

The picture on the screen is very poorly visible..

But I think this kit not for A48E.
Only kit for A48E use full screen for show info. All other kits not used top of 50 lines on screen.

Adko13 · Post 31 Oct 2019, 18:16

he should say dirty line .. because he sent it unnecessarily complicated and unclear... :/

DRIVE2 · Post 31 Oct 2019, 18:29

Sorry.

Is it possible to turn on the rest of the kits and look at the screen ?
Just apply 12V to the board's power line ? +12V, GND, Ignition (put +12V to this line).

Adko13 · Post 31 Oct 2019, 18:31

yes it is possible..

Adko13 · Post 05 Nov 2019, 14:23

NA s4 b5 does not show oil temperature, but the level shows no temperature ... Probably bad sensor? ?

does not show the range and L in the tank...

Cable is ok..

where to look for a problem?

https://youtu.be/BeJNcu7F5Ks

DRIVE2 · Post 05 Nov 2019, 17:55

Check coding in cluster -> adaptation channel 60 must not be 0. Also check coding in channel 61,62
If coding is correct, possible the cluster does not fully support CAN-bus.

Adko13 · Post 05 Nov 2019, 18:22

okay thanks

ist goood