MFA vs. 2.7 bit V6 engine

[Los_loko]

Hello, good team and forum.

I have a question, I am the owner of the Audi A4B6 (2003), which had the 3.0 ASN engine as a standard, today after the swap is 2.7 biTurbo V6. Will MFA work with such a set? Is there an option to control EGT from both turbines (two independent readings). Is it possible to control the composition of the fuel mixture with an additional probe? Lambda.

[Los_loko]

Enybody ?

[Mrimstad]

Will it work: Yes
Possible issues from missmatch with firmware/engine: Possibly
Read egt: Yes
Control fuel table: No

[autopilot]

ColorMFA support any engine, if this engine (ECU) support CAN-bus.
EGT is not possible to show (need change ECU firmware). Also as lambda, AFR, e.t.c.
You may see some values via diagnostics in ColorMFA.

[Los_loko]

Thank you Autopilot for the answer, but EGT is probably the ability to read from the serial probe. I saw on the forums of users with audi A38l 1.8t who had EGT reading on MFA. 2.7tt is a twin engine up to 1.8t but because it is a V6 there are 2 EGT sensors and I would like to read both at the same time

[autopilot]

Sorry, but EGT and other additional values possible show only via diagnostics (if this sensors present in original equipment). External sensors not possible connect to ColorMFA.