Immo 2 open doors display

sg1 · Post 15 Oct 2018, 10:54

I already installed color mfa and everything works perfect - including turbo boost, reverse gear display, and lamp failure indication. Here i must write, that last i have install without pull up resistors as you suggest ! With 10 K resistors present i have permanent lamp failure warning. Then i removed them and even without them i measured 12 V on lamp failure relay output when simulate lamp failure. When lamps are ok ther is 0 V as expected.

Only issue i have is with open door display. Of course i connect confort module with colormfa, i use a pair of twisted wires from UTP cable. Only front bonnet open is correctly displayed, but as i found it is analog connected to colormfa. It could means that confort can do not work at all, but when i unlock the car with remote colormfa display with car picture go on for some seconds. I think it means that there is can connection betwen CCM and colormfa.
Any suggestions ?
I want to check if correct firmware for IMMO2 is loaded on my colormfa, but not know how to do it. I see the version, but not for which car it is.

And finally thanks to include my translation to Slovenian language in your product. It looks that i made good job too - i found no mistakes and all text fits nice on the screen.

DRIVE2 · Post 16 Oct 2018, 13:19

I see the version, but not for which car it is.

What version is displayed ? Make photo please.

Only issue i have is with open door display.

What displayed on CAN-monitor with checked only Comfort-CAN (menu -> System -> CAN-monitor -> check Comfort only -> Watch).
ColorMFA installed to immo2 or immo3 cluster ?

And finally thanks to include my translation to Slovenian language in your product. It looks that i made good job too - i found no mistakes and all text fits nice on the screen.

Thanks to you...

sg1 · Post 17 Oct 2018, 19:47

Can monitor show No Data
Immo 2 cluster 3B0920820, 1J0959799AH ccm
FW is v2.9.4_b24

DRIVE2 · Post 17 Oct 2018, 20:27

Wrong version for immo2.
In b24 added new firmware version mark in Firmware screen for VW/Skoda.

v2.9.4_bXX - immo3 global firmware
v2.9.4fs_bXX - immo3 firmware for FullFIS cluster
v2.9.4dr_bXX - immo2 firmware

Please update to correct firmware.

sg1 · Post 21 Oct 2018, 16:18

Thank you, I updated fw and now open doors/hood/bonnet indication works perfect.
I also make some minor changes to Slovenian translation. File is atached.
Wish to position lights and low beam indication via two unused TRinputs still here...