immo3 cluster in immo2 car

Technical issues

Вопросы по установке. Монтаж, пайка, проводки...
Questions about the installation. Mounting, soldering, wiring ...
Post Reply
Posts: 2
30 Sep 2018, 15:01


Post  07 Oct 2018, 15:20

in the guide it says this ( NOTE!! If installing an Immo 3 cluster into an Immo 2 car, remove the 2 jumper resistors
labeled 000 and solder the CAN wires to the pads on the left (closer to green plug) side. If
you do not remove these wires )

Wich pads should be used ? arrow in pic please should the pads you remove the 2 000 resistors from be briged with solder or left cut ?
text says if you do not remove these 2 wires ???

Post Reply