REQUEST FOR NEW FEATURES / Предложения по новым функциям

[sg1]

Lights on icon was my wish from year or more ago too. I agree that suitable place is at left or right side of OK area.
I am sure this area is wide enough that additional icon will not interfere with other displayed data.

[fifoIV]

Lights on icon is possible to make by CAN-BUS illumination signal on immo3

[pety]

Hi.and what about up and down sliding main display?
And secon question is, is it possible to build in needle sweep (audi a4 8e) with on off in menu...
Thx

[autopilot]

what about up and down sliding main display

I'll think about this. I won `t promise.

is it possible to build in needle sweep

No. ColorMFA does not control needle/arrow.

[frost12345]

HI

Request for new Features:

accelaration-measurement (0-100):

Is it possible to change oder add serveral accelaration-measurements, not only 0-100 km/h? I realy need 100-200 km/h but maybe some 1/4 mile or 1/8 mile 0-200 km/h etc. is possible. It's very helpful if you made mods and want to test or compare with the old setting.

Thanks

BR Benjamin

[mmgherasim]

I think 'Washer fluid low' warning is broken in b32 for A4 8E. I ran out of fluid and got no warning. I remember I got this warning in b31. I checked in debug menu to see if it's activated and all my settings were just like in b31, so the warning was ON but it didn't work. I'll flash back b31 after I'm close to empty the washer fluid and see if I get the warning, which I should and report back.

[pety]

Ok. Thx for thinking about the up down sliding...

[autopilot]

I think 'Washer fluid low' warning is broken in b32 for A4 8E.

This function is not changed.
On 8E coding of cluster is affected to work this option. Main coding and adaptation coding.
Cluster must "beep" if level is really low. Even if ColorMFA does not show warning. Is a original function, ColorMFA only show info.

[sedoij]

Привет! Можно вывести на экран отображение температуры масла в коробке и обороты двигателя?
Спасибо.

[mmgherasim]

This function is not changed.
On 8E coding of cluster is affected to work this option. Main coding and adaptation coding.
Cluster must "beep" if level is really low. Even if ColorMFA does not show warning. Is a original function, ColorMFA only show info.

I know, but for some reason it didn't beep nor showed the warning. Maybe it's just a coincidence and something else is at fault. Cluster is coded correctly because I got this warning on b31. I'll dig deeper and see what I find. Thanks!

[pety]

Maybe broken buzzer in mfa

[mmgherasim]

Don't think so, I would've seen the warning message and icon in ColorMFA if it only was the buzzer broken.

[autopilot]

Можно вывести на экран отображение температуры масла в коробке и обороты двигателя?

Обороты можно, но там значения постоянно пляшут (можно в Общих данных посмотреть), мотор же не работает на фиксированных оборотах. Не очень удобно для просмотра.
А температуры масла АКПП нет на шине. Такие данные появились только на DSG коробках и то не на всех.

[paer07]

Приветствую, возможно ли реализовать обратный счетчик километров? Например для меня актуально при перемещениях по дорогам регионального назначения, где зачастую отсутствуют какие либо указатель километрожа или таблички. Выезжая из точки А, я знаю что до точки В например 73 км, и постоянно при однообразном пейзаже приходится заниматься матиматикой высчитывая сколько же осталось ехать. Будет удобно лишь при возможности выбора на основном экране(например после установки необходимого значения через меню), если реализовать как отдельную функцию без возможности быстрой смены на другие показания, то скорее всего без надобности

[autopilot]

При наличии навигатора в каждом телефоне мне кажется функция не очень полезная. Т.к. будет не удобной и не совсем точной. Машина не знает свое положение "в пространстве", а пройденный километраж может отличаться даже от ряда в котором едешь (особенно на закругленных трассах).
Есть в цветном опция "Кофе-брэйк". Там можно установить километраж до вывода сообщения. Можно попробовать поездить с этой опцией. Она не покажет сколько км осталось, но указав на 1 км меньше чем нужно выведет предупреждение на экран заранее.
А вообще конечно навигатор в такой ситуации идеально подходит.

[frost12345]

Hey Autopilot

Is this possible or too much work for unnecessary feature in you opinoin?

Is it possible to change oder add serveral accelaration-measurements, not only 0-100 km/h? I realy need 100-200 km/h but maybe some 1/4 mile or 1/8 mile 0-200 km/h etc. is possible. It's very helpful if you made mods and want to test or compare with the old setting.

Thank You.

BR

Benjamin

[autopilot]

I remember about this feature.

[frost12345]

Ok cool thank you I will wait for the next Firmware BR

[CVT]

Feature Request: Show the current gear for Multitronic (Вариатор) when on S for Audi A4 B6 and B7

Description: The Multitronic has infinitely many gear ratios when on D, however when on S it has been programmed to simulate normal automatic transmissions with 7 speeds for Audi A4 B7 and 6 speeds for Audi A4 B6. The original screen shows the current gear when in S, but the ColorMFA does not. It would be nice if it does show the number instead of showing S.

[Haribos]

Feature request :Changing line assist!
Hello Autopilot. I am thinking about installing this feature on A6C5. There are 2 possibilities - to use module from other A6 probably C7, or to use some chinese module. For the first option for now i am not familiar with the interface and does it can be implemented in the car. For the second one probably there will be need of signal when to be active(powered). It has own outputs with light and sound signalization, but i have feeling that it will be aimed all the time and will give me false signals for example during parking. For example maybe i will need one combined signal for Color MFA which contain: signal that speed is more than 15km/h and some signal from steering wheel for the angle. At the moment i have used OUT1 and OUT 2 for the fog lights, but still have OUT3 not occupied. Is it possible to have such signal on OUT3?