REQUEST FOR NEW FEATURES / Предложения по новым функциям

DRIVE2 · Post 10 Dec 2019, 14:37

Possible add support only modules with OPS (modules what displayed parking sensor info in original device like RNS or MMI).
In your car installed "simple" PDC module without OPS.
ColorMFA not get info from diagnostics and not possible show info from PDC in main screen.

Guido_T5 · Post 10 Dec 2019, 15:07

I don't know which module. At least I can see the sensors in Diag mode (measurement front and back in mm), so I was thinking that would be enough information...

DRIVE2 · Post 10 Dec 2019, 18:54

Sorry, but data from PDC is not possible to show on main screen. Only in diagnostic mode.

r3nzoll · Post 16 Dec 2019, 11:10

Is it possible to add Data Trip3? Simmilar to data trip2, reset manualy.
Asking about it, beucase I'm reseting my data trip2 in long periods and sometimes I just want to check Shorter trips. Like weekend trips, without reseting all the data from trip2.

DRIVE2 · Post 16 Dec 2019, 17:13

A very strange desire. But I will think about it.

sg1 · Post 16 Dec 2019, 17:52

I like this idea about Trip 3 very much.
Trip 1 is in practice limited to current drive (1 hour stand-by time expires even at nice lunch stop)
Trip 2 is now nice to use as long term statistic values counter.

One more trip (with manual reset) will be very useful for real trip which take whole day, weekend or even holidays.

r3nzoll · Post 16 Dec 2019, 22:24

sg1 wrote: ↑
16 Dec 2019, 17:52
I like this idea about Trip 3 very much.
Trip 1 is in practice limited to current drive (1 hour stand-by time expires even at nice lunch stop)
Trip 2 is now nice to use as long term statistic values counter.

One more trip (with manual reset) will be very useful for real trip which take whole day, weekend or even holidays.

Yes, just like that. You explained it better than me

I thought about that option after last weekend, where I wanted to save data from whole weekend trip without deleting my overal data from trip2

geos3 · Post 17 Dec 2019, 00:11

^ that. 1 vote from me also

DRIVE2 · Post 17 Dec 2019, 13:40

Ok, I will try to add.

mvkhmud · Post 21 Dec 2019, 23:39

Создайте Bluetooth-адаптер который подключается к магнитоле и работает в паре с ColorMFA (показывает название трека/номер входящего звонка и т.д.). Это увеличит спрос на ColorMFA и обрадует владельцев автомобилей. Такой Bluetooth-адаптер уже существует. Называется Dеnsiоn Gаtеwаy Prо и работает в паре со штатным экраном.

DRIVE2 · Post 22 Dec 2019, 00:14

Вы сюда приходите денсион рекламировать ?
Зачем делать то, чего и так на рынке как грязи...
Если устройство работает со штатным экраном, то и с ColorMFA будет работать так же.

JimB · Post 22 Dec 2019, 15:19

And I also remember, please add outside temperature to main screen. Thank you.

DRIVE2 · Post 23 Dec 2019, 00:49

Already added...

Igorela · Post 25 Dec 2019, 14:18

Интересна возможность изготовления полностью цветной панели на Ауди. Примерная цена? И возможно ли вообще?

DRIVE2 · Post 25 Dec 2019, 15:18

В чем смысл этой затеи ?
"Кривой" экран под форму приборки не найдете в продаже. Прямоугольный без кромсания торпедо не поставите или будут дыры по краям экрана.
А смысл этого всего ? Что выводить на него ? Просто из-за нарисованных стрелочных приборов ? В машинах этих годов нет ничего штатного, что умеет показывать инфу на таком экране. Ни нави, ни звука, ни телефона, ничего... Банально даже поддержки русского толком нет в штатных девайсах. Прикручивать потом к этому андроидных китайцев ? Или сразу в приборку андроидного гибрида всунуть чтоб умел нави, звук, телефон, парктроник, управление климатом и т.д. и т.п. ?

Управлять этим всем с 3-х кнопок без тачскрина не запаритесь ?
В общем, ИМХО, бесполезная какая-то идея...

JimB · Post 26 Dec 2019, 15:59

autopilot wrote: ↑
23 Dec 2019, 00:49
Already added...

But If I understand well, it will be in next FW version, right? Because in last firmware, in settings and trip computer, I don't see that option to show it in middle of the LCD as the main value. Thank you.

DRIVE2 · Post 26 Dec 2019, 18:01

Yes, of course it will be in next update. But I already add this feature to code and not forget about it.

sg1 · Post 27 Dec 2019, 10:24

Inspired by excellent idea of Trip 3 i get another "third option" idea.
It is about gear assistant. Now we have shift up and shift down tresholds, which are indicated with green up and down arrows.
It will be nice and usefull to add third "Redline" shift up treshold which will be represented with red up arrow.
In practice it would means that green upshift arrow just change color to red when that third treshold is reached.
Explanation: now i (and i think most users) use gear assistant upshift treshold at economy setting - 2400 rpm in my case - because in normal driving it is very rare to go to redline.
But on the other hand it will be nice to have redline indication like sport cars have too.
Hope you could manage this simple idea and other users like it too.

DRIVE2 · Post 27 Dec 2019, 14:56

Okay, I'll think about how to do it. But in one of next update. Current update is public today.

r3nzoll · Post 29 Dec 2019, 17:49

What is TP 1.6 and 2.0?

Because flashed b30 firmware yesterday and don't know if to flash b31 or skip it till next bigger update?
Thanks