Radio in safe mode after Updateprocess
Добавлено: 26 апр 2018, 21:41
Hi,
today i have installed my first colormfa in one of my Audi A2.
First, i tested it in combination with FIS Control with the preinstalled software version (i think it was v2.9.4b22 or something like that). Seems that colorMFA is working together with FIS Control in general:
https://youtu.be/7asVjRFZDgQ
As you can hear, the radio was working during this test.
Than, i started a firmware update process, but i made a mistake and did a downgrade to v2.9.4b19. Since that, my radio switched to safe mode. I updated to the latest version v2.9.4b24 directly after the downgrade. Now, b24 is installed, but my radio is still in safe mode - and i dont have the key anymore.
I checked my dash with VCDS. All measurement blocks say that communication to all CAN-devices are working. Also, i can see a lot of traffic with colorMFAs CAN-Viewer on all three CAN-buses.
IMO is also working. Enginge is starting.
Any idea what happend ?
today i have installed my first colormfa in one of my Audi A2.
First, i tested it in combination with FIS Control with the preinstalled software version (i think it was v2.9.4b22 or something like that). Seems that colorMFA is working together with FIS Control in general:
https://youtu.be/7asVjRFZDgQ
As you can hear, the radio was working during this test.
Than, i started a firmware update process, but i made a mistake and did a downgrade to v2.9.4b19. Since that, my radio switched to safe mode. I updated to the latest version v2.9.4b24 directly after the downgrade. Now, b24 is installed, but my radio is still in safe mode - and i dont have the key anymore.
I checked my dash with VCDS. All measurement blocks say that communication to all CAN-devices are working. Also, i can see a lot of traffic with colorMFAs CAN-Viewer on all three CAN-buses.
IMO is also working. Enginge is starting.
Any idea what happend ?