immobilized engine
Добавлено: 12 мар 2022, 17:06
I've just had colourMFA installed into my IMMO3 cluster (2003 Bora V6 2.8L), together with needle sweep and what installer recommended "cruise control led mod".
I now can't start the car. Engine cuts out after 1 second - see video https://www.youtube.com/watch?v=2qhTUIWK_rs.
Also sounds like the fuel pump is constantly priming https://www.youtube.com/watch?v=VKBTFPvrQ7U(when key is in ON position).
VCDS reports a bunch of trouble codes, even when cleared these all return.
Before colourMFA install, I used to have a clean VCDS report and car worked fine.
Before fitting the colourMFA, car had new aftermarket head unit, driver and rear passenger side new door lock modules and driver window button module fitted.
Any suggestions would be welcome.
I now can't start the car. Engine cuts out after 1 second - see video https://www.youtube.com/watch?v=2qhTUIWK_rs.
Also sounds like the fuel pump is constantly priming https://www.youtube.com/watch?v=VKBTFPvrQ7U(when key is in ON position).
VCDS reports a bunch of trouble codes, even when cleared these all return.
Before colourMFA install, I used to have a clean VCDS report and car worked fine.
Before fitting the colourMFA, car had new aftermarket head unit, driver and rear passenger side new door lock modules and driver window button module fitted.
Any suggestions would be welcome.