Hi! Recently I bought an Inmo 3 dash (1J5 920 826) to install it on an Inmo 2 car and later instal ColorMFA. There is any problem with this? Other times I installed Inmo 3 dashes on Inmo 2 cars without any problem, but whithout ColorMFA. Would work ColorMFA properly with this configuration?
The car is a Golf IV Inmo 2 with a 1J0 920 825 original dash.
Thank you in advance.
Install ColorMFA in Inmo 3 dash for an Inmo 2 car
Golf IV 2001 INMO 3 Dash 1J5 920 826
Immo2 firmware for ColorMFA (immo2 car, with immo2 ccm) does not support installation to FullFIS cluster (does not matter immo2 cluster or immo3).
There are no other restrictions.
There are no other restrictions.
Добавьте данные об автомобиле в подпись (профиль -> подпись). Чтоб не спрашивать постоянно... :)
Please add info about your car to you signature (profile -> edit signature). To not ask every time... :)
Please add info about your car to you signature (profile -> edit signature). To not ask every time... :)
So the case I asked its possbile? Or for installing colorMFA on an Inmo 2 car is necessary install it on an inmo 2 instrument cluster?
Golf IV 2001 INMO 3 Dash 1J5 920 826
Possible install to immo3 cluster for immo2 car (old CCM).
Need do additianal steps: remove two resistors on the cluster (comfort CAN), connect conmfort CAN wires from ColorMFA directly to cluster socket and add 2 CAN wires from CCM to cluster.
Only immo2 firmware for ColorMFA can be used.
Need do additianal steps: remove two resistors on the cluster (comfort CAN), connect conmfort CAN wires from ColorMFA directly to cluster socket and add 2 CAN wires from CCM to cluster.
Only immo2 firmware for ColorMFA can be used.
Добавьте данные об автомобиле в подпись (профиль -> подпись). Чтоб не спрашивать постоянно... :)
Please add info about your car to you signature (profile -> edit signature). To not ask every time... :)
Please add info about your car to you signature (profile -> edit signature). To not ask every time... :)
Perfect, thank you!autopilot писал(а): ↑31 июл 2021, 13:17Possible install to immo3 cluster for immo2 car (old CCM).
Need do additianal steps: remove two resistors on the cluster (comfort CAN), connect conmfort CAN wires from ColorMFA directly to cluster socket and add 2 CAN wires from CCM to cluster.
Only immo2 firmware for ColorMFA can be used.
Golf IV 2001 INMO 3 Dash 1J5 920 826