Yes, of course, it does not show the doors open, nor can data, and it does not save the configuration either.autopilot писал(а): ↑26 мар 2023, 08:40Can you clarify? Does not show the doors on the screen and there is no data on the comfort CAN bus?
You write that the same thing happens, but the main problem described above is resetting all settings when the power is turned off.
If it does not show the doors and there is no data in the CAN monitor, then the most common reason is incorrectly soldered CAN bus wires. They are interchanged (CAN-H and CAN-L).
The second common reason is incorrect installation. Perform the installation for a car with IMMO3 as if they were installing it in IMMO2. Cut the CAN bus tracks on the dashboard board. It is not right. When installing in the IMMO3 dashboard with the IMMO3 comfort unit, no tracks need to be cut.
The third most common mistake is using the wrong firmware. Firmware immo2 and immo3 are incompatible. Different CAN bus speeds. You need to use the correct version for your car.
The cables verified, all correct and without bad connections
The engine data can show them to me
I had it installed in my 2002 golf Mk4 car, in cluster fis passat 3B0 920 847 E and everything was correct, when I removed it and installed it in a 1J0 920 826 C, what was described happens to me
I always cut the tracks, I didn't know that in inmo3 it wasn't necessary, thanks
Also tried installed in another 503 cluster with the same result
When I remove the contact the blue led light on the board stops flashing
Regarding the firmware, it is also correct since it was in the Fis (b5fs) and I updated it by passing it to the half screen (b5) I can try to put the Fis again to see if it works ...