Hi,
after a while of driving and trying some thinks I got a error and the EPC-light turns on but no limp-mode. After I clear the codes (with vcds) everiting is fine. The code is:
18084-34 K132-light faulty
If this error appears I can only start the car after the second try, thats already strange. After clearing the error everyting is fine.
My ECU has Immo-Off and I think I should check my cluster-coding or is this dev. not the problem in this case? Before install the ColorMFA I got no such errors. But I think I hade change the cluster-codings.
Whats your thaugts to this?
Thanks BR
Benjamin
GET Error: 18084-35 K132 faulty
Check wires, cluster connectors, e.t.c. Debris, flux residues, solder residues, e.t.c.
ColorMFA does not connected to this lamp and not affected to work of this lamp.
ColorMFA does not connected to this lamp and not affected to work of this lamp.
Добавьте данные об автомобиле в подпись (профиль -> подпись). Чтоб не спрашивать постоянно... :)
Please add info about your car to you signature (profile -> edit signature). To not ask every time... :)
Please add info about your car to you signature (profile -> edit signature). To not ask every time... :)
-
- Сообщения: 10
- Регистрация:
- 06 янв 2019, 23:19
ok thanks, good to know and I will check these things
S4 B5 K04 Y2000
-
- Сообщения: 10
- Регистрация:
- 06 янв 2019, 23:19
after I checked my cluster and ecu-codings I recognised that my cluster was coded on Immo-3 (with immo off)- that was the Problem. After changing to the right cluster-coding everything works fine without errors (since 1500km)
I can use all features of ColorMFA without issues while driving
I can use all features of ColorMFA without issues while driving
S4 B5 K04 Y2000