ColorMFA

На vw Т5 можно картинку в виде авто сделать?

В 27ой прошивке стартовые заставки загружать надо по очереди? Сразу 4 статичные и 2 анимации не получится?
И такой вопрос... если ранее загрузил две анимации, потом чтоб их заменить, просто поверх них загружать новую?

Сразу 4 статичные и 2 анимации не получится?

"Сразу" имеется ввиду нажатием одной кнопки ? Нет, на каждую картинку придется нажимать кнопку "загрузить во флэш".

если ранее загрузил две анимации, потом чтоб их заменить, просто поверх них загружать новую?

Да. Или можно удалить текущую если она не нужна.

Hello,
It's great that in b27 we can add animations, it's a great feature, but I have a question.
I made animation <1,5 mb but in Logo loader it shows more than 3 mb. Do you know why?

LogoLoader rebuild all frame image to suitable format for ColorMFA.
In some case result image is smaller than original, in some case is bigger.

autopilot писал(а): ↑

04 фев 2019, 18:49

LogoLoader rebuild all frame image to suitable format for ColorMFA.
In some case result image is smaller than original, in some case is bigger.

Thank you for answer now I know where to look

Your are build this animation ?
e.t.c.

About animations...
Minimum frame time is 30ms. But this time is not guarantied. If used frame with full screen animation or with full screen background, the real time is much bigger. Because reading image from flash and decoding is very slow.
If possible, make background with single color. Not use gradient fill or colored image as background for animation.

I was converting this: https://www.youtube.com/watch?v=J5qD-dTM9eA to gif, but I made too much frames etc. But I'm making 480x320. Your animation is very nice, where can I find it?

I could not write any aditional logo to flash, always get fail write to flash. I tried strictly according instructions and COM port is connected, logo or animation loads, but write image to flash fails. I tried only logos i downloaded from this web site.
No problems with fw VW immo 2 upgrade to b27.
Any idea ?

where can I find it?

https://forum.xda-developers.com/androi ... a-t3351617
Need convert to 480x320, reduce frame counts and optimize size.

I could not write any aditional logo to flash, always get fail write to flash.

Is a first trying of loading. In previous firmware you load custom logo ?

Yes it is first time. I never try to load custom logo before.

Yes it is first time. I never try to load custom čogo before.

Please make photo of HW Info screen. You know where...

Here it is. I am guessing - problem could be DataFlash unknown ?

I am guessing - problem could be DataFlash unknown ?

Yes. Is a problem...
Need check soldering of small IC (8-legs, on bottom side, behind main CPU). May be one of leg is not fully soldered.

Hi.,
I have a suggest can addition the power off then show "goodbye"
thanks

Sorry, but currently made "goodbye" is not possible. And not planned in near future.

Анимация на ColorMFA поддерживается макс 1.5мб разрешением 320х480.Я правильно понял?