REQUEST FOR NEW FEATURES / Предложения по новым функциям

[autopilot]

AWD It's there as a menu option, but it doesn't open! Otherwise, the on-board computer shows the percentages for the rear axle, as well as the newton meters of the Haldex.

I see you've found the diagnostic options in hidden menu. Have you tried increasing the "KL Timeout" parameter to the maximum ?
The ColorMFA does not use diagnostic data when displaying parameters. The Haldex data on the screen (percentages and torque) is obtained from the CAN bus. The Haldex unit continuously sends a specific set of data. This has nothing to do with diagnostics.

I have a regular air conditioner, not a climate control system. Is it normal for it not to show that it is on when it is?

Not all systems send data to the CAN bus. Yes, that's normal.

[Vanhai]

I have set everything that is timed to maximum. I have also activated all the protocols. Nothing happens.

[autopilot]

Do other diagnostic adapters (like VCDS) connect normally ? Does ColorMFA itself connect to other ECUs ?
Actually, I don't know what the problem is. It should work if the K-line has no problems connecting to the Haldex unit. Is there any oxidation of the wires in the Haldex connector ?

[Vanhai]

ColorMFA connects to other available ECUs. I haven't tried it through the VCDS, I'll check it in the future. I don't know if there is oxidation, I'll see about that in the future.

[boubou]

Manual adjustments to the mirror's position when active rear gear will be in the next update (currently in the test firmware).

Hello autopilot, more explain is possible ?

Setup brighness for LowLine cluster is updated ?

Thanks.

[autopilot]

more explain is possible ?

There are currently no settings for this. The values ​​are fixed. The ability to set custom values ​​has been added.

Setup brighness for LowLine cluster is updated ?

Why? Everything works as it should.