Стартовые заставки / Start Logo

Mrimstad · Post 01 Sep 2018, 15:28

Mika28 · Post 13 Jan 2019, 07:53

На vw Т5 можно картинку в виде авто сделать?

Dalnoboyshik · Post 04 Feb 2019, 16:56

В 27ой прошивке стартовые заставки загружать надо по очереди? Сразу 4 статичные и 2 анимации не получится?
И такой вопрос... если ранее загрузил две анимации, потом чтоб их заменить, просто поверх них загружать новую?

DRIVE2 · Post 04 Feb 2019, 17:02

Сразу 4 статичные и 2 анимации не получится?

"Сразу" имеется ввиду нажатием одной кнопки ? Нет, на каждую картинку придется нажимать кнопку "загрузить во флэш".

если ранее загрузил две анимации, потом чтоб их заменить, просто поверх них загружать новую?

Да. Или можно удалить текущую если она не нужна.

r3nzoll · Post 04 Feb 2019, 18:28

Hello,
It's great that in b27 we can add animations, it's a great feature, but I have a question.
I made animation <1,5 mb but in Logo loader it shows more than 3 mb. Do you know why?

DRIVE2 · Post 04 Feb 2019, 18:49

LogoLoader rebuild all frame image to suitable format for ColorMFA.
In some case result image is smaller than original, in some case is bigger.

r3nzoll · Post 04 Feb 2019, 19:04

autopilot wrote: ↑
04 Feb 2019, 18:49
LogoLoader rebuild all frame image to suitable format for ColorMFA.
In some case result image is smaller than original, in some case is bigger.

Thank you for answer

now I know where to look

DRIVE2 · Post 04 Feb 2019, 19:07

Your are build this animation ?

e.t.c.

DRIVE2 · Post 04 Feb 2019, 19:13

About animations...
Minimum frame time is 30ms. But this time is not guarantied. If used frame with full screen animation or with full screen background, the real time is much bigger. Because reading image from flash and decoding is very slow.

If possible, make background with single color. Not use gradient fill or colored image as background for animation.

r3nzoll · Post 04 Feb 2019, 22:27

I was converting this: https://www.youtube.com/watch?v=J5qD-dTM9eA to gif, but I made too much frames etc. But I'm making 480x320. Your animation is very nice, where can I find it?

sg1 · Post 05 Feb 2019, 00:28

I could not write any aditional logo to flash, always get fail write to flash. I tried strictly according instructions and COM port is connected, logo or animation loads, but write image to flash fails. I tried only logos i downloaded from this web site.
No problems with fw VW immo 2 upgrade to b27.
Any idea ?

DRIVE2 · Post 05 Feb 2019, 02:29

where can I find it?

https://forum.xda-developers.com/androi ... a-t3351617
Need convert to 480x320, reduce frame counts and optimize size.

I could not write any aditional logo to flash, always get fail write to flash.

Is a first trying of loading. In previous firmware you load custom logo ?

sg1 · Post 05 Feb 2019, 22:53

Yes it is first time. I never try to load custom logo before.

DRIVE2 · Post 06 Feb 2019, 08:57

Yes it is first time. I never try to load custom čogo before.

Please make photo of HW Info screen. You know where...

sg1 · Post 07 Feb 2019, 10:32

Here it is. I am guessing - problem could be DataFlash unknown ?

Archi765 · Post 07 Feb 2019, 11:27

DRIVE2 · Post 07 Feb 2019, 14:08

I am guessing - problem could be DataFlash unknown ?

Yes. Is a problem...

Need check soldering of small IC (8-legs, on bottom side, behind main CPU). May be one of leg is not fully soldered.

david001750 · Post 13 Feb 2019, 06:52

Hi.,
I have a suggest can addition the power off then show "goodbye"
thanks

DRIVE2 · Post 13 Feb 2019, 13:18

Sorry, but currently made "goodbye" is not possible. And not planned in near future.

Eduard · Post 14 Feb 2019, 04:30

Анимация на ColorMFA поддерживается макс 1.5мб разрешением 320х480.Я правильно понял?