S3 8L Parktronic with graphic support

[cstmn1337]

Hello Autopilot. I found this information about the modules:

4F0 910 283 - Rear sensors, without graphic support
4F0 910 283 A - Rear and front sensors, without graphic support
4F0 910 283 B, D - rear sensors, with graphics support
4F0 910 283 C - with graphics support, rear and front sensors,
4F0 910 283 F, L - rear sensors, with graphics support, with camera support
4F0 910 283 E, G, H, P - rear and front sensors, with graphics support, with camera support

This is my new module I bought: 4F0 910 283 B
I have an original parktronic in my S3 8L. I saw the graphics visualization modules for parking and decided to buy one with the final letter B, which according to the specification has graphics support for only four rear sensors. Once I start the new module, will it get my image (OPC) for only the four rear sensors? Or do I just need a module with an end letter C that supports 8 sensors (front and rear)? Will the OPS display work with this module?



I want to ask it is possible to make OPC display in c3 8l right? Sry for my bad English...

[autopilot]

Any modules are supported. Both for 4 sensors and for 8 sensors.
If you install module for 4 sensors, ColorMFA show only 4 sensors data. If you install module for 8 sensors, ColorMFA show info for 8 sensors.
The module must be properly wired and coded correctly.

[cstmn1337]

Thank you very much. Once I'm done, I might do a Retrofit theme.