Install ColorMFA in Inmo 3 dash for an Inmo 2 car

pablobnc · Post 15 Jul 2021, 23:23

Hi! Recently I bought an Inmo 3 dash (1J5 920 826) to install it on an Inmo 2 car and later instal ColorMFA. There is any problem with this? Other times I installed Inmo 3 dashes on Inmo 2 cars without any problem, but whithout ColorMFA. Would work ColorMFA properly with this configuration?

The car is a Golf IV Inmo 2 with a 1J0 920 825 original dash.

Thank you in advance.

Post 21 Jul 2021, 19:10

Immo2 firmware for ColorMFA (immo2 car, with immo2 ccm) does not support installation to FullFIS cluster (does not matter immo2 cluster or immo3).
There are no other restrictions.

pablobnc · Post 22 Jul 2021, 14:35

So the case I asked its possbile? Or for installing colorMFA on an Inmo 2 car is necessary install it on an inmo 2 instrument cluster?

Post 31 Jul 2021, 13:17

Possible install to immo3 cluster for immo2 car (old CCM).
Need do additianal steps: remove two resistors on the cluster (comfort CAN), connect conmfort CAN wires from ColorMFA directly to cluster socket and add 2 CAN wires from CCM to cluster.
Only immo2 firmware for ColorMFA can be used.

pablobnc · Post 31 Jul 2021, 18:06

autopilot wrote: ↑
31 Jul 2021, 13:17
Possible install to immo3 cluster for immo2 car (old CCM).
Need do additianal steps: remove two resistors on the cluster (comfort CAN), connect conmfort CAN wires from ColorMFA directly to cluster socket and add 2 CAN wires from CCM to cluster.
Only immo2 firmware for ColorMFA can be used.

Perfect, thank you!