GET Error: 18084-35 K132 faulty

[frost12345]

Hi,

after a while of driving and trying some thinks I got a error and the EPC-light turns on but no limp-mode. After I clear the codes (with vcds) everiting is fine. The code is:

18084-34 K132-light faulty

If this error appears I can only start the car after the second try, thats already strange. After clearing the error everyting is fine.

My ECU has Immo-Off and I think I should check my cluster-coding or is this dev. not the problem in this case? Before install the ColorMFA I got no such errors. But I think I hade change the cluster-codings.

Whats your thaugts to this?

Thanks BR

Benjamin

[autopilot]

Check wires, cluster connectors, e.t.c. Debris, flux residues, solder residues, e.t.c.
ColorMFA does not connected to this lamp and not affected to work of this lamp.

[frost12345]

ok thanks, good to know and I will check these things

[frost12345]

after I checked my cluster and ecu-codings I recognised that my cluster was coded on Immo-3 (with immo off)- that was the Problem. After changing to the right cluster-coding everything works fine without errors (since 1500km)
I can use all features of ColorMFA without issues while driving