Страница 1 из 1
Diagnostic -> read faults but cant clear it -> timeout
Добавлено: 14 июл 2020, 15:14
frost12345
Hi,
I can read out my fault-codes but I cant clear them. I got a message timeout mode: 80. All other stuff works fine and I can clear the codes via obd-dongle or vcds no problem. I have done an Immo-off on the ecu , maybe this is the problem? But all other stuff works fine.
Thks, BR Benjamin
Diagnostic -> read faults but cant clear it -> timeout
Добавлено: 14 июл 2020, 17:49
alexnevski36
frost12345 писал(а): ↑14 июл 2020, 15:14
Hi,
I can read out my fault-codes but I cant clear them. I got a message timeout mode: 80. All other stuff works fine and I can clear the codes via obd-dongle or vcds no problem. I have done an Immo-off on the ecu , maybe this is the problem? But all other stuff works fine.
Thks, BR Benjamin
have you tried with engine running? I cannot erase faults with engine not running, but can if it is running.
Diagnostic -> read faults but cant clear it -> timeout
Добавлено: 14 июл 2020, 20:55
frost12345
Hi,
Ive already try it with the engine on but no success. My Car is an S4 B5 Y2000 Facelift .
Diagnostic -> read faults but cant clear it -> timeout
Добавлено: 17 июл 2020, 16:08
autopilot
I'll test it...
May be need adding more wait timeout after clear all faults.
Diagnostic -> read faults but cant clear it -> timeout
Добавлено: 20 июл 2020, 15:32
frost12345
ok thanks !
Diagnostic -> read faults but cant clear it -> timeout
Добавлено: 10 авг 2020, 10:15
frost12345
after I checked my cluster and ecu-codings I recognised that my cluster was coded on Immo-3 (with immo off)- that was the Problem. After changing to the right cluster-coding everything works fine without errors (since 1500km)
I can use all features of ColorMFA without issues while driving
Diagnostic -> read faults but cant clear it -> timeout
Добавлено: 11 авг 2020, 01:55
autopilot
Fine !