Small Navi mode bug with RNS-E
Добавлено: 24 ноя 2019, 15:55
I have a B5 Audi S4 with ColorMFA, currently running the b29 firmware. My car also has the RNS-E Navigation/radio. In navi mode, the ColorMFA shows the correct bar graph, arrow and other info. If I press the up/down button on the end of my wiper stalk, nothing happens to the display, but in reality it was changing the "current main screen" that is masked by the Navi screen. For example, if I was on the "Current consumption" screen before navi mode is activated, and then I press the up/down button during Navi mode, then after navi mode ends, and it returns to the main screen, it will no longer be on "Current consumption".
What's the more important problem is that during navi mode, if I press the Reset button, it correctly shows the menu and I can do other stuff. But when I exit from the menu, it doesn't always return to navi mode but goes to the main screen instead. If I press Reset o go back to the menu again and then exit the menu, it might go back to navi, or it might take a few more tries.
It would be really nice if there is a way to toggle between all three modes: Main screen, Menu or Navi. The original FIS can do this using the Reset button, but not on ColorMFA.
What's the more important problem is that during navi mode, if I press the Reset button, it correctly shows the menu and I can do other stuff. But when I exit from the menu, it doesn't always return to navi mode but goes to the main screen instead. If I press Reset o go back to the menu again and then exit the menu, it might go back to navi, or it might take a few more tries.
It would be really nice if there is a way to toggle between all three modes: Main screen, Menu or Navi. The original FIS can do this using the Reset button, but not on ColorMFA.