ColorMFA

hello i also have a problem with wiring on b6, After the connection shows only the logo and lights error .. but can not switch and get neither the menu nor anything ...

Instrument cluster Bosch... instrument cluster other than in the instructions
https://www.imageupload.net/upload-imag ... 4384_n.jpg

In A48E present only Bosch cluster. Your cluster with original color screen or mono screen ?
In instruction present photo of 2 type of mono screen cluster.

Check all connection. I think you wrong connected CAN-bus wires. In A48E all contriol button work only via CAN-bus.

I got 4pcs of displays 2x a4 b5 1x a4 b6 1x a3 8l...

Stickers is a4 and a3... 2 is not stickers...
which is for a4 b6?

https://ibb.co/rHMPcJ4
https://ibb.co/xstz0sq


it's possible that I was wrong in the boards

In your situation possible incorrect kit installed (buttons control from CAN only in A48E firmware).
But I don't know about marking... I not have selling or shipping info. Need ask Dirtylime about this.

Possible to take photo of screen installed to this cluster ? While it show any info (error, main screen or other), except logo...

Shows only logo and lights error ..

Take photo whith lights error...

The picture on the screen is very poorly visible..
But I think this kit not for A48E.
Only kit for A48E use full screen for show info. All other kits not used top of 50 lines on screen.

he should say dirty line .. because he sent it unnecessarily complicated and unclear... :/

Sorry.
Is it possible to turn on the rest of the kits and look at the screen ?
Just apply 12V to the board's power line ? +12V, GND, Ignition (put +12V to this line).

yes it is possible..

NA s4 b5 does not show oil temperature, but the level shows no temperature ... Probably bad sensor? ?

does not show the range and L in the tank...

Cable is ok..

where to look for a problem?


https://youtu.be/BeJNcu7F5Ks

Check coding in cluster -> adaptation channel 60 must not be 0. Also check coding in channel 61,62
If coding is correct, possible the cluster does not fully support CAN-bus.

okay thanks ist goood