ColorMFA

Hi,
For this error Low Oil Pressure, is colorMFA capable to display this error?
Look for example for this video: https://www.youtube.com/watch?v=uoBR_5EKqqk
Why I am asking this.. I saw in the instructions this procedure: we connect Low Level Oil (yellow led) to ColorMFA but red led for Low Oil Pressure is not connected.
Thank you!

No need to make additional connection for Oil Pressure. All data present on CAN-bus.

Thank you for this info!
Also another question.
I have an AZD engine with manual transmition. Code transmition ERT.
What Gear Ratio should I use ?
Thank you!

See this post: GEAR RATIO (Пост autopilot #4491)

Just finished installing: perfect!
One single bug: Torque is not correctly displayed.
-2, -27 etc.
This is not ok I think.
Can I provide some data to investigate this?

Small minus is possible when you car is standing still or if while driving you release the gas pedal without set gear selector to N (for manual transmission).

Negative engine torque is normal and real when braking with engine.
When driving down on step hill in low gear with no throtle it could reach pretty high numbers !

Ok. I will test on a hill with second gear. Thank you!

It works! second gear and max acceleration on the hill.. 142 nM displayed. Thank you!