mfa doesn't read small boost , 90 91 208 & 209

[HGPTNate]

Good afternoon everyone, after a little help my color mfa in my mk4 r32 turbo full fis immo 3 doesn't read measuring blocks 90,91,208 & 209 but with vcds plugged in to my obd port it reads absolutely fine. It also doesn't show boost in the smaller icons but does display boost on the main screen, trip data, summary and the boost gauge option.

Currently running firmware 29. Not sure where to go with this .....

[autopilot]

Not understand about 90,91,208,209...
If you connect to ECU in ColorMFA diagnostic and go to this group, you see any value ?

If you need show boost on main screen, need make additional connection: Подключение наддува / Boost connection

[HGPTNate]

So in diagnostic on colour mfa it doesn’t display values on 90,91,208 & 209 (r32 timing chains) but I can read these via vagcom plugged in..

Boost is displayed on gauges and works as well as
Summary
Trip Data 1 & 2
Displays on main screen as a large value

Doesn’t display as a small value in the corner when selected only displays —

[autopilot]

What you see while select 208/209 group in ColorMFA diagnostic after connect to motor ECU ?
Take some photo please.

[HGPTNate]

Will do