Hallo,
(Kann dies vielleicht jemand übersetzen?)
Ich hoffe Sie können mir weiterhelfen.
Das Display ist soweit installiert, scheint auch alles zu funktionieren. Leider wird mir aber nicht angezeigt, wenn eine Türe offen ist.
Neueste Firmware ist aufgespielt.
Mein Fahrzeug: Audi A6 4B C5 - Diesel, Baujahr 2002.
Radio: NaviPlus
Ich wäre Ihnen/Dir dankbar für Tips bzw. Hinweise, wieso dies nicht angezeigt wird.
Grüße
Audi A6 C5 4B
Check connection of TrInput1 to pin 6 in green cluster socket.
Добавьте данные об автомобиле в подпись (профиль -> подпись). Чтоб не спрашивать постоянно... :)
Please add info about your car to you signature (profile -> edit signature). To not ask every time... :)
Please add info about your car to you signature (profile -> edit signature). To not ask every time... :)
Hallo,
connection of TrInput1 to pin 6 is OK, have measured all contacts, all is good.
but no connection to "central locking system (4B0 962 258 D)" with ColorMFA.
With VCDS Version 3.11 i have contact to central locking system(4B0 962 258 D). With VCDS version 15.xx no contact is possible to central locking system...
connection of TrInput1 to pin 6 is OK, have measured all contacts, all is good.
but no connection to "central locking system (4B0 962 258 D)" with ColorMFA.
With VCDS Version 3.11 i have contact to central locking system(4B0 962 258 D). With VCDS version 15.xx no contact is possible to central locking system...
Do this:
1. Check wire presences in green socket to pin 6 in original wiring harness.
2. Take photo of ColorMFA main PCB (area marked on picture) in good quality. 3. Take photo of soldering in green socket (like on picture) in qood quality. 4. Make short video (~10sec) of screen in menu->System->Debug->Hardware->Inputs
1. Check wire presences in green socket to pin 6 in original wiring harness.
2. Take photo of ColorMFA main PCB (area marked on picture) in good quality. 3. Take photo of soldering in green socket (like on picture) in qood quality. 4. Make short video (~10sec) of screen in menu->System->Debug->Hardware->Inputs
Добавьте данные об автомобиле в подпись (профиль -> подпись). Чтоб не спрашивать постоянно... :)
Please add info about your car to you signature (profile -> edit signature). To not ask every time... :)
Please add info about your car to you signature (profile -> edit signature). To not ask every time... :)
OK, now all works fine... why? don't know...
If it repaired by himself, possible to present bad or unstable connection. And it may stop working again after a while.OK, now all works fine... why? don't know...
I'm not see any problem on PCB or in soldering.
Добавьте данные об автомобиле в подпись (профиль -> подпись). Чтоб не спрашивать постоянно... :)
Please add info about your car to you signature (profile -> edit signature). To not ask every time... :)
Please add info about your car to you signature (profile -> edit signature). To not ask every time... :)