ColorMFA

VW BORA 2004 1.8T года, из версии прошивки b5_flash_v2.9.4b26 не отображается для отображения boost, но версия прошивки b5_flash_v2.9.4b25 может отображать boost, может решить эту проблему?

Не совсем понятна проблема.
Обновитесь до текущей актуальной версии. Возможно ваша проблема уже исправлена.

I had the same problem, without seperate connection boost showed till b25, since b26 there is an extra connection needed...

What car ? What engine ?

Golf 4 1.8T, Engine: AUM, 2002

On this engine, boost show only via external connection.
Boost on CAN is not present.

But it worked till b25, i had not an external connection. I just added it after the b26 update...

maxi987 писал(а): ↑

04 апр 2019, 22:20

But it worked till b25, i had not an external connection. I just added it after the b26 update...

I think is show incorrect value.
Take photo of CAN-Monitor with active only Motor-CAN. On running engine. Data on screen can scroll, need take photo of all data.

autopilot писал(а): ↑

05 апр 2019, 03:46

maxi987 писал(а): ↑

04 апр 2019, 22:20

But it worked till b25, i had not an external connection. I just added it after the b26 update...

I think is show incorrect value.
Take photo of CAN-Monitor with active only Motor-CAN. On running engine. Data on screen can scroll, need take photo of all data.

Visually no difference between both values, with external conmection and without. Tomorrow ill take photos of can bus

If boost is really present on CAN, I'll enable this function... Did you make any changes to the engine firmware to display additional parameters ?
I have seen boost on CAN only on T5 and last A4B7 (with "big" engines like 3.0TDI).
On all other cars, value on CAN is empty or wrong...

P.S. I mean cars on which it is possible to install ColorMFA...

I changed the ecu firmware before installing colormfa, but not added additional parameters to be present on can bus

Yes, boost is present on CAN.
I'll enable in next update selection CAN as boost source for all cars if boost on CAN is present.