REQUEST FOR NEW FEATURES / Предложения по новым функциям
-
- Posts: 94
- Joined:
- 19 Feb 2018, 21:57
- Location: Ljubljana, Slovenia
Lights on icon was my wish from year or more ago too. I agree that suitable place is at left or right side of OK area.
I am sure this area is wide enough that additional icon will not interfere with other displayed data.
I am sure this area is wide enough that additional icon will not interfere with other displayed data.
Passat b5, immo 2, 1,8 T APU
-
- Posts: 11
- Joined:
- 17 Feb 2019, 23:06
Lights on icon is possible to make by CAN-BUS illumination signal on immo3
-
- Posts: 100
- Joined:
- 09 Apr 2020, 19:20
Hi.and what about up and down sliding main display?
And secon question is, is it possible to build in needle sweep (audi a4 8e) with on off in menu...
Thx
And secon question is, is it possible to build in needle sweep (audi a4 8e) with on off in menu...
Thx
-
- Posts: 2515
- Joined:
- 28 Dec 2017, 19:07
- Location: Москва
I'll think about this. I won `t promise.what about up and down sliding main display
No. ColorMFA does not control needle/arrow.is it possible to build in needle sweep
Добавьте данные об автомобиле в подпись (профиль -> подпись). Чтоб не спрашивать постоянно... :)
Please add info about your car to you signature (profile -> edit signature). To not ask every time... :)
Please add info about your car to you signature (profile -> edit signature). To not ask every time... :)
-
- Posts: 10
- Joined:
- 06 Jan 2019, 23:19
HI
Request for new Features:
accelaration-measurement (0-100):
Is it possible to change oder add serveral accelaration-measurements, not only 0-100 km/h? I realy need 100-200 km/h but maybe some 1/4 mile or 1/8 mile 0-200 km/h etc. is possible. It's very helpful if you made mods and want to test or compare with the old setting.
Thanks
BR Benjamin
Request for new Features:
accelaration-measurement (0-100):
Is it possible to change oder add serveral accelaration-measurements, not only 0-100 km/h? I realy need 100-200 km/h but maybe some 1/4 mile or 1/8 mile 0-200 km/h etc. is possible. It's very helpful if you made mods and want to test or compare with the old setting.
Thanks
BR Benjamin
S4 B5 K04 Y2000
-
- Posts: 94
- Joined:
- 11 Oct 2018, 18:01
- Location: Adjud, Vrancea, Romania
I think 'Washer fluid low' warning is broken in b32 for A4 8E. I ran out of fluid and got no warning. I remember I got this warning in b31. I checked in debug menu to see if it's activated and all my settings were just like in b31, so the warning was ON but it didn't work. I'll flash back b31 after I'm close to empty the washer fluid and see if I get the warning, which I should and report back.
AUDI A4 B7
2.0 TDI quattro BPW
ColorMFA on Color FIS
2.0 TDI quattro BPW
ColorMFA on Color FIS
-
- Posts: 2515
- Joined:
- 28 Dec 2017, 19:07
- Location: Москва
This function is not changed.I think 'Washer fluid low' warning is broken in b32 for A4 8E.
On 8E coding of cluster is affected to work this option. Main coding and adaptation coding.
Cluster must "beep" if level is really low. Even if ColorMFA does not show warning. Is a original function, ColorMFA only show info.
Добавьте данные об автомобиле в подпись (профиль -> подпись). Чтоб не спрашивать постоянно... :)
Please add info about your car to you signature (profile -> edit signature). To not ask every time... :)
Please add info about your car to you signature (profile -> edit signature). To not ask every time... :)
-
- Posts: 6
- Joined:
- 15 Jul 2018, 00:08
Привет! Можно вывести на экран отображение температуры масла в коробке и обороты двигателя?
Спасибо.
Спасибо.
VW Passat B5+, американец, 1.8T, AWM, 2002, CAN-шина, immo 3
-
- Posts: 94
- Joined:
- 11 Oct 2018, 18:01
- Location: Adjud, Vrancea, Romania
I know, but for some reason it didn't beep nor showed the warning. Maybe it's just a coincidence and something else is at fault. Cluster is coded correctly because I got this warning on b31. I'll dig deeper and see what I find. Thanks!
AUDI A4 B7
2.0 TDI quattro BPW
ColorMFA on Color FIS
2.0 TDI quattro BPW
ColorMFA on Color FIS
-
- Posts: 94
- Joined:
- 11 Oct 2018, 18:01
- Location: Adjud, Vrancea, Romania
Don't think so, I would've seen the warning message and icon in ColorMFA if it only was the buzzer broken.
AUDI A4 B7
2.0 TDI quattro BPW
ColorMFA on Color FIS
2.0 TDI quattro BPW
ColorMFA on Color FIS
-
- Posts: 2515
- Joined:
- 28 Dec 2017, 19:07
- Location: Москва
Обороты можно, но там значения постоянно пляшут (можно в Общих данных посмотреть), мотор же не работает на фиксированных оборотах. Не очень удобно для просмотра.Можно вывести на экран отображение температуры масла в коробке и обороты двигателя?
А температуры масла АКПП нет на шине. Такие данные появились только на DSG коробках и то не на всех.
Добавьте данные об автомобиле в подпись (профиль -> подпись). Чтоб не спрашивать постоянно... :)
Please add info about your car to you signature (profile -> edit signature). To not ask every time... :)
Please add info about your car to you signature (profile -> edit signature). To not ask every time... :)
-
- Posts: 4
- Joined:
- 10 Mar 2020, 12:00
Приветствую, возможно ли реализовать обратный счетчик километров? Например для меня актуально при перемещениях по дорогам регионального назначения, где зачастую отсутствуют какие либо указатель километрожа или таблички. Выезжая из точки А, я знаю что до точки В например 73 км, и постоянно при однообразном пейзаже приходится заниматься матиматикой высчитывая сколько же осталось ехать. Будет удобно лишь при возможности выбора на основном экране(например после установки необходимого значения через меню), если реализовать как отдельную функцию без возможности быстрой смены на другие показания, то скорее всего без надобности
Ауди А4 B6 1.8T AMB quattro МКПП st2
-
- Posts: 2515
- Joined:
- 28 Dec 2017, 19:07
- Location: Москва
При наличии навигатора в каждом телефоне мне кажется функция не очень полезная. Т.к. будет не удобной и не совсем точной. Машина не знает свое положение "в пространстве", а пройденный километраж может отличаться даже от ряда в котором едешь (особенно на закругленных трассах).
Есть в цветном опция "Кофе-брэйк". Там можно установить километраж до вывода сообщения. Можно попробовать поездить с этой опцией. Она не покажет сколько км осталось, но указав на 1 км меньше чем нужно выведет предупреждение на экран заранее.
А вообще конечно навигатор в такой ситуации идеально подходит.
Есть в цветном опция "Кофе-брэйк". Там можно установить километраж до вывода сообщения. Можно попробовать поездить с этой опцией. Она не покажет сколько км осталось, но указав на 1 км меньше чем нужно выведет предупреждение на экран заранее.
А вообще конечно навигатор в такой ситуации идеально подходит.
Добавьте данные об автомобиле в подпись (профиль -> подпись). Чтоб не спрашивать постоянно... :)
Please add info about your car to you signature (profile -> edit signature). To not ask every time... :)
Please add info about your car to you signature (profile -> edit signature). To not ask every time... :)
-
- Posts: 10
- Joined:
- 06 Jan 2019, 23:19
Hey Autopilot
Is this possible or too much work for unnecessary feature in you opinoin?
BR
Benjamin
Is this possible or too much work for unnecessary feature in you opinoin?
Thank You.Is it possible to change oder add serveral accelaration-measurements, not only 0-100 km/h? I realy need 100-200 km/h but maybe some 1/4 mile or 1/8 mile 0-200 km/h etc. is possible. It's very helpful if you made mods and want to test or compare with the old setting.
BR
Benjamin
S4 B5 K04 Y2000
-
- Posts: 2515
- Joined:
- 28 Dec 2017, 19:07
- Location: Москва
I remember about this feature.
Добавьте данные об автомобиле в подпись (профиль -> подпись). Чтоб не спрашивать постоянно... :)
Please add info about your car to you signature (profile -> edit signature). To not ask every time... :)
Please add info about your car to you signature (profile -> edit signature). To not ask every time... :)
-
- Posts: 10
- Joined:
- 06 Jan 2019, 23:19
Ok cool thank you I will wait for the next Firmware BR
S4 B5 K04 Y2000
-
- Posts: 7
- Joined:
- 12 Jan 2019, 21:18
- Location: Bulgaria
Feature Request: Show the current gear for Multitronic (Вариатор) when on S for Audi A4 B6 and B7
Description: The Multitronic has infinitely many gear ratios when on D, however when on S it has been programmed to simulate normal automatic transmissions with 7 speeds for Audi A4 B7 and 6 speeds for Audi A4 B6. The original screen shows the current gear when in S, but the ColorMFA does not. It would be nice if it does show the number instead of showing S.
Description: The Multitronic has infinitely many gear ratios when on D, however when on S it has been programmed to simulate normal automatic transmissions with 7 speeds for Audi A4 B7 and 6 speeds for Audi A4 B6. The original screen shows the current gear when in S, but the ColorMFA does not. It would be nice if it does show the number instead of showing S.
-
- Posts: 55
- Joined:
- 30 Sep 2018, 18:23
- Location: Sofia, Bulgaria
Feature request :Changing line assist!
Hello Autopilot. I am thinking about installing this feature on A6C5. There are 2 possibilities - to use module from other A6 probably C7, or to use some chinese module. For the first option for now i am not familiar with the interface and does it can be implemented in the car. For the second one probably there will be need of signal when to be active(powered). It has own outputs with light and sound signalization, but i have feeling that it will be aimed all the time and will give me false signals for example during parking. For example maybe i will need one combined signal for Color MFA which contain: signal that speed is more than 15km/h and some signal from steering wheel for the angle. At the moment i have used OUT1 and OUT 2 for the fog lights, but still have OUT3 not occupied. Is it possible to have such signal on OUT3?
Hello Autopilot. I am thinking about installing this feature on A6C5. There are 2 possibilities - to use module from other A6 probably C7, or to use some chinese module. For the first option for now i am not familiar with the interface and does it can be implemented in the car. For the second one probably there will be need of signal when to be active(powered). It has own outputs with light and sound signalization, but i have feeling that it will be aimed all the time and will give me false signals for example during parking. For example maybe i will need one combined signal for Color MFA which contain: signal that speed is more than 15km/h and some signal from steering wheel for the angle. At the moment i have used OUT1 and OUT 2 for the fog lights, but still have OUT3 not occupied. Is it possible to have such signal on OUT3?
Audi A6 4B C5 4,2(ASG) MY2002