The TFSI engines have a fuel pressure sensor inside. You could use that. But as you already wrote, unfortunately I only have an analog output signal that is processed in the engine control unit. Unfortunately, my engine control unit cannot do this. But I'm at least glad that the tire pressure control works perfectly in your system. You can not have everything.
The sensor also withstands oil pressure, I tested it
REQUEST FOR NEW FEATURES / Предложения по новым функциям
I know about the fuel pressure sensor on the TFSI. But there is still nowhere to connect it in ColorMFA.
You can make your own device that will transmit data from these sensors to the CAN bus. See above for information on what data ColorMFA understands on CAN-bus.
You can make your own device that will transmit data from these sensors to the CAN bus. See above for information on what data ColorMFA understands on CAN-bus.
Добавьте данные об автомобиле в подпись (профиль -> подпись). Чтоб не спрашивать постоянно... :)
Please add info about your car to you signature (profile -> edit signature). To not ask every time... :)
Please add info about your car to you signature (profile -> edit signature). To not ask every time... :)
Hi regarding the low oil level message does the car actually need to be started and running for the low oil level meassge to come on.. or should it come on even if just the ignition is switched on.. I drained my my oil for service and thought I check and see if low oil level comes on.. but it didn't..