REQUEST FOR NEW FEATURES / Предложения по новым функциям

[autopilot]

navigation from RNS-E

1. RNS-E and dashboard must be coded as in original for navigation.
2. If navigation is active (route is laid or compas is active), on top right corner of screen is present green text "NAVI". If text is present, press and hold (~2sec) "Reset" button to show navi on screen. To return to main screen press and hold "Reset" again.

In what car you installed ColorMFA ?

[TimosGreece]

In the top of the right corner indeed present green text NAVI for 2 or 3 seconds and disappear then. RNS-E and dashboard are coded as in original for navigation. I didn’t know that needed to press and hold for 2 seconds reset. I have Audi A4 B6. I will try this next time! Thank you for the support!

[autopilot]

present green text NAVI for 2 or 3 seconds and disappear then

If it disappeared, you not switch to navi mode.
Text is displayed while navigation is stay active. If it not active, you not switch to show navi.

What version of firmware you used ? If very old (b10, b12 and so on), please update to new version.
And possible some Info-CAN problem in last b22 version (will be fixed in next releases). Please use b19 or b21 if you need use navi.

[Irbiss]

To Green 18 must connect only TrInput4 !!! Not 8 or 1.

My mistake, i cut the wrong wire...
Thx for support, everything is running.

Holger

[TimosGreece]

present green text NAVI for 2 or 3 seconds and disappear then

If it disappeared, you not switch to navi mode.
Text is displayed while navigation is stay active. If it not active, you not switch to show navi.

What version of firmware you used ? If very old (b10, b12 and so on), please update to new version.
And possible some Info-CAN problem in last b22 version (will be fixed in next releases). Please use b19 or b21 if you need use navi.

I use MFDB V3.1 and the latest firmware b22

[Houdini]

And how about egt in Audi A4 B5?

[Irbiss]

Any more "hidden" features and connections ?

Is not "hidden" features.
For VW/Skoda:
TrInput9 and TrInput10 - lamp control module (4B0 919 471 A) - not original equipment
TrInput9 - main lamp error
TrInput10 - brake lamp error

TrInput11 - rear gear (manual transmission)
TrInput12 - error from Dynamic Headlight Range Control module (original Xenon)

Thats all.

Is it possible to install this for Golf Mk4 from 2002 and how?
Trinput11 is clear.

Holger

[Disi77]

mmhhh i cant rerad it in the Install-Manual.....

[Disi77]

1. Controll-Symbol for aktive Mirrow-Heating?
2. a free-configuration for fatigue detection (example: 200km or 2 h nonstopdrive)

[autopilot]

Is it possible to install this for Golf Mk4 from 2002 and how?

Yes, it's possible. But I'm not install this features.
Is not "original" (except rear gear) functions.
About rear gear... Just connect wire from rear light directly to TrInput11.
You may find empty (realy empty) pin on Blue or Green socket, connect TrInput11 to this pin inside dashboard. And rear light wire connect to this pin in external connector.

i cant rerad it in the Install-Manual.....

rear gear is added only in b22 firmware.
All others is not original equipment.

1. Controll-Symbol for aktive Mirrow-Heating?
2. a free-configuration for fatigue detection (example: 200km or 2 h nonstopdrive)

1. No.
2. Planed. But I don't know when...

And how about egt in Audi A4 B5?

External sensors is not supported. And not planed.

[Irbiss]

Ok, Trinput 9, 10 and 12 works with 12 Volt like Trinput 11?

Holger

[autopilot]

All TrInput work with up to 16V (car battery/alternator voltage)
But different "no error/default" state.
TrInput9 and 10 - not connected or short to GND = no error. Short to +12 = error
TrInput11 - not connected or short to GND = no rear gear. Short to +12 = rear gear
TrInput12 - short to +12 = no error. Unconnected or short to GND = error

TrInput12 need activate in hidden menu. It not check DHC error by default.

[Irbiss]

Thx, where is the hidden menu?

[autopilot]

where is the hidden menu?

Is a secret.

No... Realy you must goto menu->System->Screensave
Press and hold "Down" button while on left bottom corner not appeared 'debug on' (~25sec).
After that you must see menu->System->Debug menu.
DO NOT CHANGE ANY OPTIONS IF YOU DO NOT KNOW WHAT YOU ARE DOING.

To disable this mode, goto menu->System->Screensave
Press and hold "Down" button while on left bottom corner text 'debug on' is disappeared (~25sec).

Activation DHC for VW/Skoda will be in firmware from b23.

[Irbiss]

come on...

[autopilot]

just highlight my previous post.

[Irbiss]

It not check DHC error by default.

Yoe mean this?
What is "DHC"?

Holger

[autopilot]

What is "DHC"?

Dynamic Headlight range Control
May be is HRC - Headlight Range Control...

You ask about TrInput's. TrInput12 is used/reserved to check Dynamic Headlight Range Control error.

[planeboy18]

Radio info for B5A4. This is the number 1 thing the B5 people have asked me about.

[Irbiss]

For hidden menu, you mean this?
goto menu->System->Firmware (no select "yes" or "no", just stay in this screen)
- press and hold "Down" button while not displayed "ZAGR" below firmware version.

Holger