ColorMFA

greeting,

i have a audi s3 8l from 2002, now i tried vag tacho to read the cluster eprom to tranfser it to the colormfa cluster.
now vag tacho does not support my cluster...
i have a eprom programmer that i can use but is there a chip on the cluster that i can solder off and read it?
or is there a program that i can use to read my cluster?
here is some info of the cluster0:
VDO 110.008 946/012
audi 8L0 920 932 B
i hope you guys can help me so i can get my colormfa working

thanks
kind regards

Try VAG EEPROM Programmer to reading/writing dump: https://www.google.com/search?q=vag+eep ... mmer+1.19g
Reading/writing dump via typical USB K-Line adapter (like this: https://www.ebay.com/itm/USB-Cable-KKL- ... 3560280604 ).

no it does not work.. i get a error cant find ecu

You are right connected cluster and K-Line adapter ?
VAG EEPROM does not read old VDO A3 cluster ?

I use a k-line cable and i can use it with vcds lite on com1 so it should work on VAG eeprom right? When i use com 1 it's trying to read thé cluster bit then i get a error Cant find ECU... I wil post a video with thé problem so it's a bit more clear

oke so after 20 times trying and always getting the cant find ecu code. it finally worked its funny becus, i was making the video and then it worked thanks for the support.

its funny becus, i was making the video and then it worked

Fine !