Brake pad error
Добавлено: 09 ноя 2018, 03:31
My Passat W8 has sensors to warn of brake pad wear (when the wire in the pad is broken due to wear.)
Since I have aftermarket pads that do not have this wire, I used VCDS to disabled the warning. (This was before I had the ColorMFA installed.)
After having the ColorMFA installed, it always displays the brake pad error, even though I verified with VCDS that it should still be turned off.
Is there any way to make the ColorMFA honor the cluster setting to not display this error? Or is my only solution now to hard-wire the connectors at the wheels with jumper wires?
Since I have aftermarket pads that do not have this wire, I used VCDS to disabled the warning. (This was before I had the ColorMFA installed.)
After having the ColorMFA installed, it always displays the brake pad error, even though I verified with VCDS that it should still be turned off.
Is there any way to make the ColorMFA honor the cluster setting to not display this error? Or is my only solution now to hard-wire the connectors at the wheels with jumper wires?