Страница 1 из 1

immo3 cluster in immo2 car

Добавлено: 07 окт 2018, 15:20
Brumbassen
hi
in the guide it says this ( NOTE!! If installing an Immo 3 cluster into an Immo 2 car, remove the 2 jumper resistors
labeled 000 and solder the CAN wires to the pads on the left (closer to green plug) side. If
you do not remove these wires )

Wich pads should be used ? arrow in pic please should the pads you remove the 2 000 resistors from be briged with solder or left cut ?
text says if you do not remove these 2 wires ???

regards